SECTION I.
INTRODUCTION
Code
Explanation
1. Scope
A
Assemblies which are not procured or stocked as
This manual lists repair parts, special tools, test and
such, but are made up of two or more units.
support equipment required for the performance of
Such component units carry individual stock
organizational and direct support maintenance of the
numbers and descriptions, are procured and
hammer, pile driver.
stocked separately and can be assembled to
2. General
form the required assembly at indicated
This Repair Parts and Special Tools List is divided into
maintenance categories.
the following sections:
X
Parts and assemblies that are not procured or
stocked because the failure rate is normally
composite listing of repair parts, special tools, test and
below that of the applicable end item or
support equipment having quantitative allowances for
component.
The failure of such part or
initial stockage at the organizational level.
assembly should result in retirement of the end
item from the supply system.
authorized for the performance of maintenance at the
X1 Repair parts which are not procured or stocked.
organizational level in figure and item number sequence.
The requirement for such items will be filled by
c. Special Toots, Test and Support Equipment
the next higher assembly or component.
Section IV. (Not Applicable).
X2 Repair parts, special tools and test equipment
which are not stocked and have no foreseen
authorized for the performance of maintenance at the
mortality. The indicated maintenance category
direct support level in figure and item number sequence.
requiring such repair parts will attempt to obtain
e. Special Tools, Test aid Support Equipment
the parts through cannibalization or salvage, the
Section VI. (Not Applicable).
item may be requisitioned with exception data,
f. Federal Stock Number and Reference Number
from the end item manager, for immediate use.
G
Major assemblies that are procured with PEMA
ascending numerical sequence, followed by a list of
funds for initial issue only as exchange
reference numbers appearing in all of the listings, in
assemblies at DSU and GSU level. These
alpha-numeric sequence, cross-referenced to the
assemblies will not be stocked above the DS
illustration figure number and item number.
and GS level or returned to depot supply level.
NOTE
(2) Maintenance code indicates the lowest
Items not illustrated are cross-
level of maintenance authorized to install the listed item.
referenced
to
assembly
group
The maintenance codes are:
number.
Code
Explanation
O .................... Organizational maintenance
3. Explanation of Columns
F ..................... Direct support maintenance
The following provides an explanation of columns in the
(3) Recoverability code indicates whether
unserviceable items should be returned for recovery or
a. Source, Maintenance, and Recoverability Codes
salvage.
Items not coded are expendable.
(SMR).
Recoverability codes are:
(1) Source code indicates the selection status
Code
Explanation
and source for the listed item. Source codes used are:
R
Applied to repair parts, (assemblies and
Code
Explanation
components) special tools and test equipment
P
Repair parts, special tools and test equipment
which are considered economically reparable at
supplied from the GSA/DSA, or Army supply
direct and general support maintenance levels.
system, and authorized for use at indicated
When the item is no longer economically
maintenance categories.
reparable, it is normally disposed of at the GS
P2 Repair parts, special tools and test equipment
level. When supply considerations dictate,
some of these repair parts may be listed for
purposes because the combat or military
automatic return to supply for depot level repair
essentiality of the end item dictated that a
as set forth in AR 710-50. When so listed, they
minimum quantity be available in the supply
will be replaced by supply on an exchange
system.
basis.
M
Repair parts, special tools and test equipment
which are not procured or stocked, as such, in
S
Repair parts, special tools, test equipment and
the supply system but are to be manufactured
assemblies which are economically reparable
at indicated maintenance levels.
iii