TM 5-3895-332-34
CHAPTER 1
INTRODUCTION
Section I. GENERAL
c. Report
of
errors,
omissions,
and
1-1. Scope
recommendations for improving this publication by the
a. These instructions are published for the use of
individual user is encouraged.
Reports should be
support maintenance personnel maintaining the MKT
submitted on DA Form 2028 (Recommended Changed
Model DA35 Diesel Pile Hammer.
They provide
to Publications) and forwarded direct to Commanding
information on the maintenance of equipment, which is
General, U.S. Army Mobility Equipment Command,
beyond the scope of the tools, equipment, personnel or
ATTN,: AMSME-MPP, 4300 Goodfellow Boulevard, St.
supplies normally available to using organizations.
Louis, Mo. 63120.
b. Forms and Records. Report all equipment
improvement recommendations as prescribed by TM 38-
570.
Section II. DESCRIPTION AND DATA
(b) If cam stop head height is not in
1-2. Description
accordance with dimensional limits shown in table 1-1,
A general description of the hammer, the location and
replace control cam.
description of the identification and instruction plates,
c. Nut and Bolt Torque Data.
and information on differences in models are contained
in Chapter 1, Operator and Organizational Maintenance
Trip mechanism access cover bolts .............. 100 ft.
lb.
Manual, TM 5-3895-332-12.
Lubricating oil pump mounting nuts ................. 60 ft.
lb.
Fuel pump mounting nuts ............................... 60 ft.
lb.
1-3. Tabulated Data
Fuel pump check valve nut ............................ 150 ft.
lb.
Fuel pump top nut ........................................... 40 ft.
lb.
a. General.
This paragraph contains all the
Fuel pimp lock plate cap screws ...................... 40 ft.
lb.
overhaul data pertinent to Direct and General Support
Fuel and oil line hex nuts ................................. 30 ft.
lb.
Maintenance personnel.
Guide bracket bolts- ....................................... 100 ft.
lb.
b. Fuel Pump Repair and Replacement Standards.
Make the following measurement while the fuel pump is
mounted on hammer with the ram-piston down:
lists
manufacturer's
sizes,
tolerances,
desired
(1) Control cam and cam stop measurements.
clearances, and maximum allowable wear and
(a) Measure the distance from under
clearances. Refer to figure 1-1 for compression ring,
the cam stop head to top nut. If measurement is more
end gap.
than 17/ 32, check cam stop head height (table 1-1).
1-1
