APPENDIX D
REPAIR PARTS LIST
Section I. INTRODUCTION
nance codes only. Source codes, Recoverability codes, and
1. Scope
Maintenance Allowances are not assigned this category.
This appendix lists repair parts and special tools
a. Source, Maintenance, and Recoverability
required for the performance of organizational,
codes (SMR).
direct support and general support, maintenance
of the Hammer, Pile Driver.
(1) Source code. Indicates the selection
status and source for the listed item. Source
codes used are-
2. General
Explanation
Code
This Repair Parts and Special Tools List is di-
P
Applied to repair parts which are stocked in or
vided into the following sections:
supplied from DSA/GSA or Army supply sys-
a. Prescribed Loud Allowance (PLA) -
Section
tem, and authorized for use at indicated mainte-
nance categories.
II. A composite listing of repair parts,
special
tools, test and support equipment having
quanti-
P2
Applied to repair parts which are procured and
tative allowances for initial stockage at
the or-
stocked for insurance purposes because the com-
ganizational level.
bat or military essentiality of the end item dic-
tates that a minimum quantity be available in the
b. Repair Parts-Section III. A list of repair
supply system.
parts authorized for the performance of mainte-
nance at the organizational level in figure and
Applied to repair parts which are not procured
M
item number sequence.
or stocked but are to be manufactured at indi-
cated maintenance categories.
c. Special Tools, Test and Support Equipment
-Section IV. Not applicable.
Applied to assemblies which are not procured or
A
stocked as such but are made up of two or more
d. Repair Parts-Section V. A list of repair
units, each of which carry individual stock num-
parts authorized for the performance of mainte-
bers and descriptions and are procured and
nance at the direct support and general support
stocked and can be assembled by units at indi-
level in figure and item number sequence.
cated maintenance categories.
e. Special Tools, Test and Support Equipment
X
Applied to parts and assemblies which are not
-Section VI. Not applicable.
procured or stocked; the mortality of which
normally is below that of the applicable end item;
f. Federal Stock Number and Reference Num-
and the failure of which should result in retire-
ber Index-Section VII. A list of Federal stock
ment of the end item from the supply system.
numbers in ascending numerical sequence, fol-
Applied to repair parts which are not procured
lowed by a list of reference numbers appearing
X1
or stocked, the requirement for which will be
in all of the listings, in ascending alpha-numeric
supplied by use of the next higher assembly or
sequence, cross-referenced to the illustration fig-
component.
ure number and item number.
Applied to repair parts which are not stocked.
X2
The indicated maintenance category requiring
3. Explanation of Columns
such repair parts will attempt to obtain them
The following provides an explanation of columns
through cannibalization; if not obtainable through
in the tabular lists in sections II through VI:
cannibalization, such repair parts will be requi-
sitioned with supporting justification through
Note. Common hardware items known to be readily
normal supply channels.
available in Army supply channels are assigned Mainte-
AGO 20049A
D-1
