(13, fig. 6-5). Remove the attaching hardware
and remove the starting device.
b. Cleaning and Inspection.
(1) Clean starting device with an approved
solvent and dry thoroughly.
(2) Inspect starting device for cracks,
breaks, or other damage. Replace if defective.
c. Installation. Install starting device in re-
verse order of removal.
3-29. Disassembly and Reassembly
a. Disassembly. Disassemble the starting de-
vice as illustrated in figure 3-11.
b. Cleaning and Inspection.
(1) Clean all parts with an approved clean-
ing solvent and dry thoroughly.
(2) Inspect all parts for cracks, breaks, and
relief valve, removal and installation.
other damage. Replace all damaged and defective
parts.
3-28. Removal, Installation, Cleaning
and Inspection
c. Reassembly. Reassemble starting device in
a. Removal. Remove the starting device cover
reverse order of disassembly.
Section X. DRIVING HEAD AND ADAPTER
3-31. Removal, Installation, Cleaning
3-30. General
and Inspection
The adapter assembly consists of a male and
a. Remove and install the driving head as il-
female unit and is used in conjunction with the
lustrated in figure 2-4.
driving head. The adapter assembly is placed
b. Clean all parts with an approved cleaning
between the anvil recess and the driving head.
solvent and dry thoroughly.
The driving head is furnished with a filler and
c. Inspect all parts for cracks, breaks, and
four filler tips. Figure 3-12 illustrates the pile
other damage. Replace a damaged or defective
contours fitting the driving head.
part.
3-10
