Appendix B
INTERVAL
ITEM
NO
B
D
A
W
M
ITEM TO BE INSPECTED
PROCEDURE: CHECK FOR AND HAVE REPAIRED, FILLED, OR ADJUSTED AS NEEDED
PERFORM ALL OPERATOR PMCS FIRST
1.
2.
3.
4.
Check inner cylinder end ring clearance (P. 13, Para 10.2, manufacturer’s manual).
If clearance is greater than .050 (1.25mm), replace the rings. Ref: P. 13,
Para 10.3 manufacturer’s manual.
Check compression: Ref: P. 13, section 10.2.2, manufacturer’s manual.
Check the catch groove on the upper cylinder. The corners must be square. File
rounded corners. Ref: P. 13, para 10.2.3, manufacturer’s manual.
Clean the pipe joint filter. Ref: P. 8 para 7.1.9, manufacturer’s manual.
